Skip to main content

South Korea starts using 3-D printing for ROKAF's F-15K fighters support.


| 2015
a
World Defense & Security News - South Korea
 
 
South Korea starts using 3-D printing for ROKAF's F-15K fighters support
 
The Republic of Korea Air Force (ROKAF) has introduced three-dimensional printing in its production of engine components for fighter jets which helps cut budget and time on maintenance, it said Thursday. So far this year, 14 of the ROKAF's F- 15K fighter jets have been repaired with 3-D printed high-pressure turbine shrouds, an engine component, according to the country's Air Force.
     
South Korea starts using 3 D printing for ROKAF s F 15K fighters support 640 001A ROKAF F-15K Slam Eagle multirole fighter aircraft 
     
The engine part originally costs 40 million won ($34,900) per unit and takes about 60 days to procure from abroad,

With the introduction of the new method, the cost went down to 3 million won with the procurement time cut to 20 days, the ROKAF said.

The Air Force developed the 3-D printed component over two years in collaboration with Insstek, a local metal 3-D printing firm, since finding an abrasion in the turbine shrouds of F-15Ks' F110 engines in 2012.

The U.S.-based engine producer, GE Aviation, approved the quality and safety of the component printing, according to the Air Force.

Spurred on by the feat, the Air Force has also produced samples of three other airplane parts and 13 components for ground-based equipment through 3-D printing, the ROKAF added.

If the new components are mass-produced, it may reduce the South Korean Air Force's maintenance budget by 130 million won each year, it also noted.
 

 

Copyright © 2019 - 2024 Army Recognition | Webdesign by Zzam